Off Road Vehicles banner

Transfer case leaking

659 Views 2 Replies 2 Participants Last post by  muddinmachine
After I was done wheeling the last time I was home, I was putting the truck in storage till I come home again and I saw that my transfer case is leaking from the seal around the front drive shaft. I dont remember off hand what type it is, but it is mated to a 700r4 tranny. My question is how hard would it be to open up the transfer case and fix it? and to see if there is damage on the inside that started the leak?

thanks

Nick
1 - 3 of 3 Posts
It could of just been the seal that cracked open, but its not really that hard to replace. But if you are not mechanical, it might be more difficult.
I have built everything on the truck from the ground up except the T-case and axels. Never had to mess with those yet. Is there something special that I need to know about when dealing with the T-case??

Thanks
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top