Off Road Vehicles banner

tranny filter torx size?

684 Views 8 Replies 5 Participants Last post by  chizzle1
what size is the torx bit that fits the tranny filter?

Also, when I install the pan, filter, and RTV, how long do I need to wait before adding fluid?
Should I wait an hour or so to let the RTV (red) setup?

I am also putting some RTV around the drain plug/sender unit I have put together.
Did most of yall mount them in the side or on the bottom? I am wondering because I do not want the sender unit (about 1 1/2 inches long) to interfere with the tranny operations.


thanks
1 - 9 of 9 Posts
Theres is a tech article about it. :bigthumb:

MIke.
you're not suppose to put rtv on the pan gasket. and ya, wait an hour or so. i'm not sure what size that is, but i have the fold out kind that has like 7 different sizes on it from sears. one of those worked.
Mikeg1005 wrote: Theres is a tech article about it.

MIke.

that's the first place i looked, but it doesn't list the size. I have changed/serviced the tranny before but I don't remember what size it is.

I have a set that (I borrowed from the shop) of 10 that go from T10 to T50, so it should be one of those.
yeah I cant remember what size it is exactly but I have the same set from T10 to T55. One of them worked.
I'll make a note of what size it is and post it up when I'm done later.
Thats cool. :bigthumb:
i want to say its a t20 for some reason
-Josh
:withstupid: I believe it was the 20, it was the 3rd from the smallest in my set (which starts at 10 and goes up in increments of 5 IIRC)
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top