Off Road Vehicles banner
1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Hey! On the 2002 Dodge ram 1500 4X4 is jacking the front end of the truck and turning the tortion bars up a good way to get a couple of inches with out lifting it. How many turns will it take to get by and should i go all the way up! Thanks if you can help!
 

·
Registered
Joined
·
5,376 Posts
I havent heard of anyone doing them them self , But on the ford F150 7 turns is about 2". the thread size should be the same. Firestone tire dealer does the chevys in my area for about $30. give them a call.
Later
 

·
Registered
Joined
·
3,036 Posts
and make sure you take it to get an alignment afterward, because every thing will change from doing so. i found out the hardway on my 2wd nissan when i was 16 (i still have that truck, in pieces though!). i didnt even think about if it would affect the alignment or not. wore out a set of tires in less then 6 months.
 
1 - 3 of 3 Posts
Top