Off Road Vehicles banner

tachometer

419 Views 4 Replies 2 Participants Last post by  robike
where do our trucks get the info needed for the tach gauge? is it the crankshaft position sensor? i'm just wondering. i know where all the other gauge input come from.
1 - 5 of 5 Posts
on my 318 i tapped into the ignition coil wire i beleive. As you look into the engine bay it was about half way down on the left side of the block. I can go look at it and tell you exactly which wire to tap into if you want. Asuming the 318 and 360 are the same.
Evan
i'm just wondering where the computer gets its reading for the gauge.
i'm just wondering where the computer gets its reading for the gauge.
i'm just wondering where the computer gets its reading for the gauge.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top