Off Road Vehicles banner
1 - 1 of 1 Posts

· Registered
219 Posts
Discussion Starter · #1 ·
I know dodge has a large tolerance for leveling theor trucks. I have always noticed that my truck sits a bit lower on the driver side in the rear. Most cases that I have heard of with Dodges are that the front end in crooked. My truck sits about 1 inch lower on the driverside. I would like to keep the blocks and everything the same under each side of the truck, but that may sem like the best way to fix the problem. I was wondering if rearching the spring is a good idea to keep both sides uniform. Anyone else try and fix a prob such as this? Ideas?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.