I have a set of 3" Grizzley double bend bars. I have landed on the very hard several times. The only damage that has occured is the straight edge on the bottom of the panel is bent a little. Nothing a little hammer and a 2X4 can't handle.. DDGETHS
if you are going to get nerf bars, spend the extra money and get the stainless steel ones, chrome rusts too easily, and then you will spend more time scrubbing the rust off them than actually using them.
I bought a pair of the smittybilt nerf bars and then had our local Line-X shop spray them for me so I wouldn't have a rust problem, ever. And against my white truck they look sweet. I didn't put the stainless ones on because I don't like the look of all chrome on a white truck. But if it were any other color I would've went stainless.
You can get them from <!-- BBCode u2 Start -->http://www.allprooffroad.com" TARGET="_blank<!-- BBCode u2 End --> (I assume you knew this, since that is where the picture is from).
<!-- BBCode u2 Start -->http://www.rockstomper.com" TARGET="_blank<!-- BBCode u2 End --> has some like that also.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, drivetrain, and more!