Off Road Vehicles banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Jason did you use any kind of lubricant on the poly bushings that go into the control arms? Also were you able to realign the lower control arm cam bolt indicators with original setting? I was told that the new Pro-Comp lift kit lower control arms were longer than stock and I would not be able to realign marks.If so I was going to try and make both sides equal till I can get to alignment shop. Any help would be greatly appreciated.
 

·
Premium Member
Joined
·
9,227 Posts
All 3" lifts use the same length control arms (Rancho, Skyjacker and Pro-Comp at least I know for sure) as stock. Of course this was 4 years ago and Pro-Comp may have changed their design a bit.

I added high-temp bearing grease to the poly bushing before installing and have had no problems and I never serviced them.

I was able to get the cam bolts close (the marks rubed off with the application of pentrating lube).
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Thanks for the info JASON,things should go very smoothly. I can't wait to get going Sat.
I'll let you know how it turns out
THANKS !!!
 
1 - 3 of 3 Posts
Top