Off Road Vehicles banner

Harland sharp rockers

748 Views 5 Replies 3 Participants Last post by  Robert97dodge
Who here has had experience with them? As of now I plan on purchasing a set of 1:7 rockers to accommodate my stock cam, as I will not be replacing it. Also, since I'm not replacing my cam, do I need adjustable rockers or non? I figured non adjustables will be just fine but I'm not 100%... Thanks :bigthumb:
1 - 6 of 6 Posts
On 2005-11-21 16:08, ToddT wrote:
Who here has had experience with them? As of now I plan on purchasing a set of 1:7 rockers to accommodate my stock cam, as I will not be replacing it. Also, since I'm not replacing my cam, do I need adjustable rockers or non? I figured non adjustables will be just fine but I'm not 100%... Thanks :bigthumb:

I just ordered my set of 1.7RR's today from john at southeast. Hopefully they will be here before this weekend and I can get them installed before friday. I am driving to shreveport and I want to see how they help out with gas if any.
Ok sweet, so you ordered the non-adj? Also, what did you pay with shipping?
Thanks!

Oh, do you have that web site address also?
I have a set of Non Adj. Harland Sharp 1.7 RR's on my Ram. I did notice power, the most for a bolt on mod. My mileage went up 1 mpg also....It was well worth the $310 shipped!

Rick
Ok thanks for the info. where did you purchase yours? That's 40 bucks cheaper than what I was going to pay...
On 2005-11-21 18:25, ToddT wrote:
Ok sweet, so you ordered the non-adj? Also, what did you pay with shipping?
Thanks!

Oh, do you have that web site address also?

I am not sure if the are the adjustable or not. I just told john that I wanted a set of 1.7 RR's. They were $331 shipped to my door. This is his email address. [email protected] . It is not southeastrt.com. It is now southeastperformance.com Also there is a banner up at the top you can click on it to get to his website.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top