Dana 44 is a Dana 44 right?

as long as its not a high pinion you should be fine. IH (I don't believe) ever had HP.

god i thought our dodges were the only ones with those {expletive}ty cad units.

On 2005-12-01 04:49, hieneken49 wrote:
god i thought our dodges were the only ones with those {expletive}ty cad units.

Click to expand...

They are, but the center section hasn't changed since inception of the 30 spline side gears. The early D44s were either 16 or 19 spline at the carrier...once they switched to 30 spline at the carrier there have been little to no change.

I used a 1970 Jeep D44 TracLoc (from a rear D44) in the front of my 94 1500 Ram...even used the gears and the bearings were the same too.

steved

Thats what I was thinking that they used the same internals and just changed the housing/axle setup. Thanks for the info guys :bigthumb:

There are also reverse cut d44's too...

so i can get a d44 with locking hubs and it will bolt up?

On 2005-12-01 10:33, hieneken49 wrote:
so i can get a d44 with locking hubs and it will bolt up?

Click to expand...

simple answer, nope.
the original post asked about the gears.

On 2005-12-01 10:31, Dodge 85 rc wrote:
There are also reverse cut d44's too...

Click to expand...

read my first post

Could you put the knuckles and lock outs onto the rams 44 ?

No the inner C part of the ram axle where the knuckle attaches with the ball joints is kind of a dodge only thing the way they did it. The old (93 back) trucks would swap knuckles from GM's.