Off Road Vehicles banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3,818 Posts
Discussion Starter · #1 ·
Does anyone know how to straighten out a front axle. The driver side front tire is closer to the back of the front fender than the passenger side one is, therefore I get some tire rubbage there. The control arm mounting bracket on the driver side axle is bent forward towards the coil, and rubbed it a one point, so I know that side should be farther forward. Has anyone else had this, and is it a problem? The tires are aligned straight but I dont like how close that tire is to the fender. Any ideas?
 

·
Registered
Joined
·
3,036 Posts
if the mounts are bent, there isnt much you can do except to bend them back as close to spec as possible. if you have the double flex, check your measurements for the links again. you could twist the lower control arm bolt on the axle to move it forward to compensate, but that screws up your caster by doing so.
 

·
Registered
Joined
·
1,234 Posts
Bad TRACK-BAR? Replace it out with a DT unit. See the tech section for installation.

DT Products & Fabrication
Toll Free 1-888-776-2403
Tech Line 1-520-776-4129
484 EZ Street, Prescott, AZ 86301
 

·
Registered
Joined
·
3,818 Posts
Discussion Starter · #4 ·
thanks...i am going to give DT a call.
 
1 - 4 of 4 Posts
Top