Off Road Vehicles banner
1 - 1 of 1 Posts

140 Posts
Discussion Starter · #1 ·
I am looking at the Doetsch 5" Suspension lift for my 2wd 1998 Ford F150. The kit basically consists of a 3" spindle, 2" front lift springs and a 2" rear block. Can I install a 2.5" spacer on the front for additional lift? It says that the 2.5" spacer requires aftermarket control arms. Will the Doetsch ones work(Not sure if the 5" kit has control arms)?Also can I take out the rear block and put 4-5" leafs in the back?

Where can I buy aftermarket control arms and about how much are they going to cost?

Here is the Doetsch Kit
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.