Off Road Vehicles banner
1 - 3 of 3 Posts

·
Banned
Joined
·
1,533 Posts
Discussion Starter · #1 ·
So reading through the instructions (PA bpdy lift)it says there are eight bolts to loosen on a Quad cab (cab portion) and eight bolts to loosen on the long bed (bed portion). Now my question is that I have 14 lift blocks that are 3" x 3" but I need 16. I do have two lift blocks that are 3" tall and 2" wide...what are they used for? Just wanting to make sure I have everything I need. :):
 

·
Registered
Joined
·
8,237 Posts
in the instructions, it should have a list of parts that come with the kit. no? check that list, or call <!-- BBCode u2 Start -->http://www.performanceaccessories.com" TARGET="_blank<!-- BBCode u2 End -->
 

·
Premium Member
Joined
·
9,227 Posts
The samller blocks are for the rearmost bolts ont eh bed. This is becuase the bumper brackets and such need that extra bit of room. I did not use mine since I have a custom rear bumper that uses teh factory mounting style. If you use bumper relcoation brackets, I think you need to use the samller blocks.
 
1 - 3 of 3 Posts
Top