Off Road Vehicles banner

1 - 2 of 2 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter #1
Is there alot to cause concern? Or am I just worring about nothing? I want to run 35's, but don't want to cause pre-mature wear and tear on the 4x4 components. I am used to driving IFS trucks, not Solid Axle trucks, so I don't know a whole lot about these set ups.

Thanks
Bob
 

·
Registered
Joined
·
87 Posts
A solid axle truck should be able to handle more stress than an IFS truck under the same circumstances. I have 35x12.50 on my 89 Bronco with twin I beam. I haven't had any problems yet, so i would think that if I can get away with it, then you should have absolutely no problems.
 
1 - 2 of 2 Posts
Top