what size socket for axle hub nut

Discussion in 'Dodge 4x4' started by waz, May 21, 2007.

  1. waz

    waz
    Expand Collapse
    New Member

    23
    0
    Trophy Points:
    0
    2001 dodge ram 1500

    need to replace u joints on front axle.

    Anyone know what size socket I need to remove the hub nut?
     
  2. Tani1500

    Tani1500
    Expand Collapse
    New Member

    1,923
    0
    Trophy Points:
    0
    look in the tech section in the banner on the top of this page. theres a great write up on it with all the info... im just to lazy to look it up for ya
     

  3. BlueDodgeRam

    BlueDodgeRam
    Expand Collapse
    New Member

    1,024
    0
    Trophy Points:
    0
  4. HeavyDuty02

    HeavyDuty02
    Expand Collapse
    New Member

    298
    0
    Trophy Points:
    0
    just a tip but you dont need to take the axle nut off to replace the u-joints. just pull the 3 bolts on the back of the hub and replace the u joints with the hub on, its a little heavier, but it saves you a stub shaft. and im speaking from experience.
     
  5. waz

    waz
    Expand Collapse
    New Member

    23
    0
    Trophy Points:
    0



    I was thinking about doing it like that. I did that two years ago when I dod the ball joints. I thought it might be to hard to get at the u joint with the hub attached. Maybe I'll try it. save me from buying a socket.
     

Share This Page