PavementSucks

I recently installed a 0-3" DT Trac Bar and I'm happy with the results. It was fairly simple to install and with no extra parts. There were also no unexpected suprises. Thanks to all who recomended it!

Great. The UPS guy just dropped off mine today.

I think I mentioned this earlier in another thread.... just check that one bolt that requires a washer. Not sure which one it is.. but PM Archer he can tell you.

If you have welder access... weld the bracket to frame and yer good.

Other than that.. the only other flaw of the DT is "suppossedly" the HEIM.

I can name more than 5 folks that wheel hard with a DT and haven't had a lick of problem with the heim in many many miles.

As a side note.. YES.. HEIM's will wear... but a $40 HEIM is better than a nearly $100 rebuild kit for the Skyjoker... not to mention the Cam bolt replacement cost.....

Holy Christ, Ive had my DT in for like 6 months. Thank you Glenn for finally replying to my thread. LOL

Well I don't check dates...

If it comes up in latest posts...

bah.. nevermind.. just CHECK THE FREAKIN BOLT !

Ill make sure and do that Glenn thanks for the info. LOL

Since this old thread was revived,

How is the DT holding up for ya???

Absoloutley no problems at all. I havent welded anything and havent had to tighten a single bolt.

2 for DT

GOD RAM IT were did you get yours from and how much?

Glad it's holding up good for ya GodRamIt Just before I put my used DT on the truck I put a new heim on and it was only $24 Canadian. Easy enough to change and cheap enough to replace if needed down the road.